Menu

The Love of Christoffersen 274

barbera32fabian's blog

Handle Your Pipes Problems With These Tips

Article writer-Bruce Futtrup

Doing your own plumbing repairs can have many benefits. You can save money by not having to call a plumber and pay for their labor. You can also gain a sense of accomplishment by learning new skills and completing tasks yourself.In this article you will find a few ideas that you could find to be very handy.

Avoid frozen pipes this winter! Keep a small trickle of water dripping from faucets, and wrap your uninsulated pipes with foam or newspaper. If possible, keep the doors open between unheated and heated rooms. In an unheated area such as a garage or laundry room, keep a small heater next to the pipes. Remember to do this before the first cold snap hits.

Group all of your plumbing repairs before scheduling a plumber to come out. Check all of your fixtures and faucets. If anything is dripping, running or clogged, make a list for the plumber. That way, when the plumber comes, they can do all of the jobs in one visit. This will cut down on charges.

Before you can fix a toilet that does not flush properly, it is important that you find out what is causing the problem. Depending on what the problem is, you may be able to fix it yourself. However, more complicated toilet flushing problems may require the services of a plumber.

Drain the sediment from the bottom of your hot water heater twice a year to keep the hot water heater working at its optimal levels. Simply open the drain valve and allow the water to run out into a bucket until the water runs clear. Then close the drain valve.

Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.

To avoid wasting water and having a potentially high water bill, check your home for leaky faucets periodically. Fix any leaks that you find right away. You may be able to do the repair yourself, but if not, you may have to seek the services of a plumber to make the repairs.

Beware of black water in your toilet tank. Chances are, the color is caused from too much magnesium or iron in your water. Although this is usually harmless, it can be annoying for some people. If it is iron or magnesium in your water, the only way to fix it is by filtering the water.





If your sewer is backed up, there are things you can do to troubleshoot and clean, including renting equipment like a main line cable. However, often times this does not fully take care of the problem. A professional needs to assess the issue then, using a camera method, and thoroughly cleaning the main line.

If your sink is letting rusty water out and it will not drain, it is mostly likely because of the biological scum and grease that is built up in the pipes. You need to have your drains professionally cleaned, allowing maximum flow through your drains. Your drains must be open completely.

Using a snake tool to remove blockages is very easy. Just insert the tool a few inches into the drain, and then turn the handle to change the direction of the snake head and search for blockages. Continue moving down slowly and searching until a Go Back

Comment

Blog Search

Comments

There are currently no blog comments.